Linksys Extender Setup: The 5-Minute Guide to WPS Configuration

Wish to add linksys extender device to your home networking system? But don’t want to spend a lot of time in confusing technical setup? If so then WPS based configuration method is perfect for you. You can easily add your device to your home network system within 5 minutes by following the WPS based configuration. You need not to perform any technical change to the network settings. With this method you can add the device to your network system very quickly. Here is step by step information which you can follow to configure the device from installing hardware of the device to adding it with your home network system. 

Installation Of Device Hardware 

• Installation of device hardware begins with the unboxing of the device. You have to verify that your box contains every required item as mentioned on it. Along with the extender unit inside the box you will find a power adapter, ethernet cable and user manual. 
• After unboxing the device you have to look for a place to put it. Just be sure the location you are choosing to put your range extender device is within the range of the host router device. Placing the device a lot far from the host device creates trouble for you in configuring it. In addition to this you have to be very careful while placing the device as it should not be next to radio frequency devices or any heavy metal object. Also avoid placing them in corners and next two thick walls. 
• When placement is decided you need to power up the device by connecting it with the power outlet. Wait for your extender device to boot properly till the LED on the device turns solid green. When the device LED gets stable you can initiate the configuration. 

Configuration Of Device 

• To configure your device you have to start looking for the WPS button on it. Also look for the WPS button on the router device. After locating the WPS button on both the devices you can initiate the process. 
• First push the WPS button on the router device and you will notice its WPS LED will start blinking faster. Within the next 2 minutes you need to push the WPS button on the extender device. 
• After pushing the button on both devices you have to keep an eye on your range extender device. Its LED indicator will help you in confirming that the process is a success or a failure. 
• Note: Prior to initiating the connection, your router is compatible with WPS based connection. 

Communicate Us 

Hope the above given 5 minute guide to WPS configuration is useful for you. But if you find any difficulty in completing the configuration using WPS method or desire to customize the network web based linksys extender setup method then our team is here to assist you. You can call the below available number anytime to get help. In addition to the setup our team will assist you with network boosting and troubleshooting common issues also.

---